After the installation of the steam solenoid valve, it is necessary to pass the medium to test the operation for several times, and it can be put into formal use after confirming that it is normal.
The dirt inside and outside of the large valve and on the suction and suction surfaces should be cleaned regularly, taking care not to damage the sealing surface.
When the steam solenoid valve is not used for a long time, the manual valve should be closed before the valve is restarted. When the steam solenoid valve is restarted, the condensate should be removed and the test operation should be performed several times. It can be put into use when the switch is normal.
When the steam solenoid valve is removed from the pipe and not in use, the internal parts should be wiped clean and stored with compressed air.
When using for a long time, if the seal between the piston and the seat is not good, the piston sealing surface can be re-ground and then ground with the seat.
When working, pay attention to the pressure gauge before and after the valve, the working pressure shall not exceed the rated pressure, and the working pressure difference must be within the range of rated pressure difference. When the working pressure exceeds the rated pressure or the working pressure difference exceeds the rated pressure difference, the steam solenoid valve should be stopped in use, and the manual valve should be closed before and after to avoid the steam solenoid valve explosion and leakage.